Skip to content
How To Program Liftmaster Garage Door Opener To Car. Choose the button on the homelink control panel you want to operate the garage door opener. Press and hold the remote.
Pick any of the buttons you would like to use to operate your liftmaster device. Choose the button on the homelink control panel you want to operate the garage door opener. Locate the “program” mode on your max series remote.
Press And Release The “Learn” Button.
Find the garage door opener panel in your car. Within 30 seconds of pressing. Locate the ‘program’ button on your garage door opener or keypad.
Press And Hold The Remote.
Press and release your garage door opener’s learn button. Locate the “learn” button on your liftmaster opener. If your liftmaster opener has a myq control panel,.
Press And Release The Learn Button (Press And Release Twice If Your Liftmaster Opener Is Equipped With A Myq Control Panel).;
Holding the homelink button will connect the car to the machine’s signal. During those 30 seconds, press down and hold the learn button on the handheld remote control you want to use to operate the garage door. Hold your current garage door remote 2 in (5.1 cm) from the control.
These Are The Steps To Follow When Doing Liftmaster Garage Door Opener Programming For Standard Remote Controls:
Program a remote control to a door control with a learn button; Make sure your garage door is closed but not disengaged and your trolley. Locate the garage door opener’s learn button.
Connect Your Car And Home With Homelink® And Liftmaster®.
Hold the remote control close to the control panel. If the pairing was successful, the light on your liftmaster machine will blink once. Setting up your car's garage door opener will only take a few minutes if you follow these three steps: